These needles are specially designed for sewing jute. Here, Fernando sews the sides tight with his needle and jute twine. These smaller strips are also reused year after year whenever possible – nothing is wasted at my farm.Īs Fernando pulls the burlap taut, Pete screws in a piece of wood at the bottom, securing it to the stake. The strips are about six to eight inches long – just long enough to accommodate two or three screws that will keep the burlap secure. Smaller wooden strips are secured every two to three feet at the foot of these specimens. Unused stakes help to carefully lift the burlap in place. Once all the framing is complete, the burlap is carefully pulled above all the boxwood. Two-inch screws are used to connect the stakes of each frame. These one-and-a-half by one-inch pieces are cut right here at my farm and can be used again and again. Here he is creating a shorter frame, so the burlap can cover the plants but not the stone wall. Pete also uses wooden stakes to bolster the burlap from the bottom. The crossbar at the top creates additional support for the frame. These frames peak at least one foot above the plants so even the heaviest snow doesn’t weigh the burlap down and crush the tender foliage.Īnd remember, these boxwood specimens also grow a little more every year, so the covers and frames have to be adjusted each season. This season, I decided I did not want any metal stakes to be placed in between the shrubs, so they are built teepee style with stakes angled from the bottom to the top. This is one of the metal frames secured above the boxwood located outside my Winter House.īecause this area is tighter than the expansive Boxwood Allee, we used metal and wood stakes to build the burlap frames. This time every year, everyone on my outdoor grounds crew is busy covering the boxwood around the farm with protective burlap.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |